John Bean Lifts · Two-Post
EELS540A / EELS541A
Heavy loads, lifted quickly and safely — extra-long 62" arms and heavy-duty steel pulleys built for large and heavy-duty vehicles — installed, inspected, and serviced by Auto Lift Solutions.
Questions first? info@autoliftfl.com — we answer fast.
Sold through Snap-on · serviced by us
John Bean is Snap-on's wheel-service line, sold through Snap-on's own representatives. Shopping for one? Give us a call and we'll put you in touch with the local authorized rep — no runaround. Already running one? We're an authorized service provider: installation, repair, parts, and ALI inspection. Book service for your EELS540A / EELS541A → · Looking for a new lift? We're an authorized Challenger distributor: see the Challenger range →
Rugged and ready for the demanding jobs
Robustly constructed 62-inch arms distribute weight across the columns, while heavy-duty steel pulleys cut the load on the equalization cables for a long service life.
Three-stage front & rear arms
Three-stage arms front and rear accommodate a wide range of vehicles, and the standard screw-pad and adapter set covers pick-up points for nearly every vehicle on the market.
Low-profile urethane pads
Low-maintenance, heavy-duty urethane pads are built to last and accommodate a wide range of manufacturer-recommended lifting points.
Stack adapters on deck
Heavy-duty stack adapters reach truck frame pick-up points and store in the organizer rack for quick access. A single-point airlock release disengages both columns at once.
The data plate
The numbers that matter — straight from John Bean's spec sheet.
Specifications per John Bean (Snap-on® Equipment). EELS540A standard, EELS541A extended height — each installs at your choice of three heights and three widths.
Will it fit your shop?
Three measurements decide it. Grab a tape measure — or send us these numbers and we'll confirm it fits your bay.
Your choice of 13½', 14', or 14½' installation height — the extended EELS541A runs 186" – 198".
Installs at 10', 10½', or 11' between columns to match your bay and the vehicles you spot.
John Bean's recommended bay footprint for the 16K, standard or extended.
Where we come in on a EELS540A / EELS541A
Wherever you buy it, this is the part we handle — anywhere in Florida.
Repair and parts
Authorized John Bean service provider — cylinders, cables, locks, power units, and controls. We rebuild hydraulic cylinders in-house in Micanopy, so a discontinued part is not the end of the lift.
ALI-certified inspection
Annual inspection by ALI Certified Lift Inspectors with the serialized sticker and the paperwork — logged in our FieldSvc platform so the history is there when you need it.
Installation and relocation
New delivery, added bay, or a move across town — we set, anchor, and load-test John Bean lifts to spec and commission them properly, whoever you bought them from.
Need a hand with a EELS540A / EELS541A?
Installing one, or fixing one that's down — either way the form comes preloaded with this model, so you only have to tell us what you need. A photo of the data plate gets you a parts answer on the first call.