Home / Service & Repair
Service & Repair · Florida
Lift repair, when a bay is down.
A lift that won't go up, won't come down, or won't stay put costs you a bay. We repair two-post, four-post, scissor, and heavy-duty lifts from every major brand, anywhere in Florida. We're based in Gainesville. Depending on how far you are and how busy we are, it can take some time to get to you, and we'll tell you up front when we can be there.
Problems we fix every week
If it sounds like one of these, send a photo and a short description — it helps us bring the right parts the first time.
Locks won't set or won't release
Worn lock pawls, stretched or broken lock cables, or a sticking air valve on four-posts and heavy-duty two-posts.
One side lifts higher than the other
Usually the equalizer cables are stretched or out of adjustment, and sometimes there's a problem in one of the cylinders.
The lift drifts down
A leaking check valve, a bad lowering valve, or a cylinder seal letting fluid bypass. We find out which before we replace anything.
Leaking cylinder or hoses
Hoses and fittings get replaced. A leaking cylinder can usually be resealed or rebuilt in our shop, which costs less than replacing it.
The motor hums but nothing moves
It could be the pump, the motor, the start capacitor, or low fluid. The power unit gets tested, not just swapped.
Frayed cables, worn arms, and missing pads
Lifting cables, arm restraint gears, pins, and pads get replaced with the right parts for your model.
How a repair goes
Tell us what it's doing
Use the form or call. Include a photo of the data plate, since the make, model, and serial number let us quote parts on the first call.
We diagnose on site
We look over the whole lift, not just the part that failed, and explain what's wrong before any work starts.
Fix it and check it
Once it's repaired, the lift is run through its full range and every lock position is checked. If it's due, we can inspect it on the same visit.
Parts, including the hard-to-find ones
We source parts directly from the manufacturers and through aftermarket suppliers, so we can usually find what your lift needs, even on older models. When a part isn't available anywhere, we can often have it made, including lifting cables built to spec. Leaking cylinders are rebuilt in our Gainesville shop, which usually costs less than a new cylinder. Our hydraulic shop also takes cylinders, hoses, and pumps off tractors, trailers, and equipment — see hydraulicrepairgnv.com.
Brands we repair
Authorized service provider for Challenger, BendPak, Mohawk, and Snap-on (John Bean, Wheeltronics). We also repair Rotary, Forward, Dannmar, Atlas, Titan, Stertil-Koni, and most other lifts you'll find in a Florida shop.
Repair questions
Should I keep using a lift that's acting up?
No. If the locks aren't engaging, a cable looks frayed, or the lift drifts, take it out of service until it's looked at. Those are the failures that drop a vehicle.
Can you get parts for an old or discontinued lift?
Usually. We source parts directly from the manufacturers and through aftermarket suppliers, and cross-reference across brands. When a part isn't made anymore, we can often have one made, including custom lifting cables.
Do you repair lifts outside of the Gainesville area?
Yes, anywhere in Florida. Depending on how far you are and how busy we are, it can take some time to get to you, and we'll give you a realistic date when you call. Travel is itemized on the quote.
What should I send when I request a repair?
A photo of the data plate, a photo of the problem, and a sentence or two about what the lift is doing. That's usually enough to bring the right parts the first time.
Tell us what you need.
Use the form, or just call. A photo of the lift's data plate saves a round of questions. Monday–Friday 8–5, weekends by appointment.