Mohawk Lifts · Mobile Column
MP-18 / MP-24 / MP-30
Mobile columns with 18,000 to 30,000 lbs of capacity each — mix and match for total configurations from 32,000 to 240,000 lbs, and turn any flat slab into a heavy-truck bay in minutes — installed, inspected, and serviced by Auto Lift Solutions.
Questions first? info@autoliftfl.com — we answer fast.
Mohawk sells it · we install and service it
Mohawk sells this one factory-direct, and that works out fine — we're an authorized Mohawk installer and service provider. Order it from Mohawk and we'll meet the freight truck: set, anchored, load-tested, and certified with our own ALI sticker. After that we're the ones who maintain it. Book service for your MP-18 / MP-24 / MP-30 → · Looking for a new lift? We're an authorized Challenger distributor: see the Challenger range →
A service bay you can roll anywhere
One operator positions the columns; any column can run the whole synchronized set.
Forklift-channel construction
Built from heavy 5¾" or 7" U.S.-made forklift-channel steel with barrel-type roller bearings on the carriages — no plastic slide blocks or rollers to wear out.
19 locks, easy handling
Nineteen mechanical lock positions every 3" starting at 12", locking fork pins, a low-mounted power unit, and dual pallet-jack steering wheels that drop under load to prevent movement.
Wireless 24 V DC option
Battery-powered columns run on twin 12 V deep-cycle U.S.-made batteries — 30+ full lift cycles per charge while retaining 75% capacity, with no power cords across the floor.
The data plate
The numbers that matter — straight from Mohawk's spec sheet.
Spec table shows the MP-18; 24,000 and 30,000 lb-per-column models complete the series. Columns run individually, in pairs, or as a synchronized set.
Will it fit your shop?
Mobile columns care about the vehicle, not the building. Check these three numbers against your fleet.
Working height under the chassis — enough for tall technicians to stand under most trucks.
The adjustable forks grip this range with no wheel reducers; tires up to 48" diameter.
Any hard, level surface works — shop floor or outdoor pad.
Where we come in on a MP-18 / MP-24 / MP-30
Wherever you buy it, this is the part we handle — anywhere in Florida.
Repair and parts
Authorized Mohawk service provider — cylinders, cables, locks, power units, and controls. We rebuild hydraulic cylinders in-house in Micanopy, so a discontinued part is not the end of the lift.
ALI-certified inspection
Annual inspection by ALI Certified Lift Inspectors with the serialized sticker and the paperwork — logged in our FieldSvc platform so the history is there when you need it.
Installation and relocation
New delivery, added bay, or a move across town — we set, anchor, and load-test Mohawk lifts to spec and commission them properly, whoever you bought them from.
Need a hand with a MP-18 / MP-24 / MP-30?
Installing one, or fixing one that's down — either way the form comes preloaded with this model, so you only have to tell us what you need. A photo of the data plate gets you a parts answer on the first call.