Mohawk Lifts · Two-Post · ALI Certified
TP-26 / TP-30
ALI Certified 26,000 and 30,000 lb two-posts cut from 7" x 1" forklift-mast channel — full under-vehicle access for medium-duty fleet trucks, without digging up your floor — installed, inspected, and serviced by Auto Lift Solutions.
Questions first? info@autoliftfl.com — we answer fast.
Mohawk sells it · we install and service it
Mohawk sells this one factory-direct, and that works out fine — we're an authorized Mohawk installer and service provider. Order it from Mohawk and we'll meet the freight truck: set, anchored, load-tested, and certified with our own ALI sticker. After that we're the ones who maintain it. Book service for your TP-26 / TP-30 → · Looking for a new lift? We're an authorized Challenger distributor: see the Challenger range →
Heavy-duty lifts for heavy-duty vehicles
Surface-mounted strength that replaces in-ground lifts — no tanks, no excavation, decades of service.
7" x 1" mast channel steel
Columns of 7"-wide by 1"-thick forklift mast channel on a 48" base — not formed sheet metal — delivering stability that lasts for decades of full-capacity lifts.
Certified, redundant safety
ALI Certified to OSHA and ANSI/ALI ALCTV-2006. Twelve-position 1½"-thick steel locks engage every 6" from 5" up to the full 6' 7" rise, with air-actuated release and automatic re-engagement.
Direct drive, zero grease
Direct-drive lifting rods — no cables, chains, or pulleys to wear — with carriages on double-sealed, self-lubricating 5" steel ball-bearing rollers. Hand-held pendant control comes standard.
The data plate
The numbers that matter — straight from Mohawk's spec sheet.
Specifications per Mohawk Lifts (TP-26 / TP-30 WB). 5", 7½", and 10" stackable truck adaptors included standard; optional 3-stage arms available. Mohawk's Extended Lifetime Cylinder Seal Warranty supplies the seals themselves to the original purchaser only — it does not cover the rebuild labour, which is work we do in-house.
Will it fit your shop?
Three measurements decide it. Grab a tape measure — or send us these numbers and we'll confirm it fits your bay.
Overhead lines run at 16' standard, adjust to your ceiling, or route in-floor.
Column-to-column footprint (17' on the wide-base model) — plan a 16-foot bay minimum.
4,000 psi mix: 12" for the standard base or 8" for the wide-base model, with 1" Wej-it anchor bolts included.
Where we come in on a TP-26 / TP-30
Wherever you buy it, this is the part we handle — anywhere in Florida.
Repair and parts
Authorized Mohawk service provider — cylinders, cables, locks, power units, and controls. We rebuild hydraulic cylinders in-house in Micanopy, so a discontinued part is not the end of the lift.
ALI-certified inspection
Annual inspection by ALI Certified Lift Inspectors with the serialized sticker and the paperwork — logged in our FieldSvc platform so the history is there when you need it.
Installation and relocation
New delivery, added bay, or a move across town — we set, anchor, and load-test Mohawk lifts to spec and commission them properly, whoever you bought them from.
Need a hand with a TP-26 / TP-30?
Installing one, or fixing one that's down — either way the form comes preloaded with this model, so you only have to tell us what you need. A photo of the data plate gets you a parts answer on the first call.