Mohawk Lifts · Four-Post
Vertical Rise (VRL)
The heaviest-built vertical rise lift in the world — 35,000 to 99,000 lb capacities on runways that sit flush with the floor when lowered — installed, inspected, and serviced by Auto Lift Solutions.
Questions first? info@autoliftfl.com — we answer fast.
Mohawk sells it · we install and service it
Mohawk sells this one factory-direct, and that works out fine — we're an authorized Mohawk installer and service provider. Order it from Mohawk and we'll meet the freight truck: set, anchored, load-tested, and certified with our own ALI sticker. After that we're the ones who maintain it. Book service for your Vertical Rise (VRL) → · Looking for a new lift? We're an authorized Challenger distributor: see the Challenger range →
Bridge-grade runways, flush-floor convenience
Surface, recessed, or flush mount — when it's down it disappears into the floor, and when it's up you get 79 to 82 inches of rise.
Segmented box-girder runways
Runways built like bridge spans resist sagging and twisting under concentrated loads, weighing up to 40% more than competing models for a longer service life.
Closed-loop leveling
Mohawk's exclusive closed-loop hydraulic/mechanical system holds the runways level within ⅛" regardless of weight distribution — no corroding electronic sensors or cryptic fault codes.
13" more rise than rivals
A towering 79–82" of lift — up to 13" higher than competing models — with optional 26,400 to 44,000 lb rolling jacks for true wheels-free brake, tire, and axle work.
The data plate
The numbers that matter — straight from Mohawk's spec sheet.
Specifications per Mohawk Lifts. Installs surface-mounted, recessed-pit, or flush-mounted. Per Mohawk's disclaimer, the VRL is manufactured in Italy.
Will it fit your shop?
Three measurements decide it. Grab a tape measure — or send us these numbers and we'll confirm it fits your bay.
Sized to the vehicle — from single-axle trucks to 48-foot commercial equipment.
Standard configuration; Type C heavy models run 119.7" wide.
4,000 psi at 6" minimum — flush-mount installs need pit work, which we coordinate.
Where we come in on a Vertical Rise (VRL)
Wherever you buy it, this is the part we handle — anywhere in Florida.
Repair and parts
Authorized Mohawk service provider — cylinders, cables, locks, power units, and controls. We rebuild hydraulic cylinders in-house in Micanopy, so a discontinued part is not the end of the lift.
ALI-certified inspection
Annual inspection by ALI Certified Lift Inspectors with the serialized sticker and the paperwork — logged in our FieldSvc platform so the history is there when you need it.
Installation and relocation
New delivery, added bay, or a move across town — we set, anchor, and load-test Mohawk lifts to spec and commission them properly, whoever you bought them from.
Need a hand with a Vertical Rise (VRL)?
Installing one, or fixing one that's down — either way the form comes preloaded with this model, so you only have to tell us what you need. A photo of the data plate gets you a parts answer on the first call.